In production practice, we found that hydraulic system failures caused by hydraulic oil accounted for 75% of the entire hydraulic failure rate, so how to effectively clean the oil tank is particularly important.

Shunhao Factory will introduce you the clear cleaning measures.

1. The new hydraulic oil tank formed by welding shall be treated as follows before phosphating.

• Use a spatula to thoroughly remove the welding slag and weld nodules at the surrounding welds.
• Use a file to clean the burrs and burrs of the oil tank orifice and the connecting threaded orifices everywhere.
• Wipe all parts with a lint-free cloth and clean kerosene.
• Use compressed air to blow off the dust on the surface of the oil tank and the cleaned parts.
• If you need to install a gasket on the plane of the sealing cover, you must make the gasket in advance.

2. Clean the appearance of the oil tank after phosphating

• Use a spatula to clean the phosphating solution residues and particles on the inner surface of the oil tank.
• If there are rust spots, use the sand cloth to remove rust, and apply phosphating solution to the rust-removed parts, and clean the phosphating solution residue after 2 minutes.
• Clean kerosene with a lint-free cloth, clean the oil ports of the connecting threads everywhere and blow dry with compressed air, seal the oil port with a clean screw plug in time, and thoroughly scrub the inner surface of the tank with clean kerosene.
• Knead the dough with clean anti-wear hydraulic oil (L-HM46#), paste the welds, holes, corners and other parts of the surface one by one, and repeat the operation until the dough is free of impurities, fine dust and particles.
• Тщательно продуйте внутреннюю часть масляного бака сжатым воздухом и нанесите чистое противоизносное гидравлическое масло L-HM46# (для предотвращения коррозии внутренней части масляного бака).
• Если очищенный масляный бак пока не собран, его следует немедленно закрыть, а можно заклеить большой лентой. И наденьте крышку масляного бака, чтобы предотвратить вторичное загрязнение, и поставьте ее в правильное положение, чтобы избежать ударов.

Гидравлические формовочные машины для меламина , производимые Shunhao, поддерживаются тайваньскими технологиями, при правильной эксплуатации и надлежащем обслуживании они могут быть долговечными и станут лучшим помощником для фабрик по производству меламиновой посуды!